If you think your factory radio is too outdated to be compatible with some upgraded and modern features, it will be wise of you to upgrade it with a new aftermarket stereo which can be ideal enough to be compatible with a wide of comprehensive features. Now I’d like to share an easy-to-understand 2013 2014 2015 2016 KIA K3 car stereo installation instruction from Seicane with you. If you have the same or similar dashboard and would like to replace your factory radio, you can refer to the following installation instruction.
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2013 2014 2015 2016 KIA K3 car stereo installation instruction
1. Use a plastic removal tool to pry the panel below the AC control and remove the panel.
2. There is one screw on the left bottom, remove it with a screwdriver.
3. Remove the radio trim panel with the plastic removal tool and then unplug the connector at the back of it.
4. Unscrew the screws that are holding the radio on the dashboard.
5. Softly pull out the original car radio.
6. Disconnect connectors and cables at the back of the radio.
7. Check all the accessories for the new Seicane car radio.
8. Connect the harnesses to the back of the new Seicane car radio.
9. Connect the Seicane car radio to your original radio’s plugs.
10. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. Put the new Seicane car radio into the dash.
12. Put everything into their original place. All the installation is done.
Wish you can get some inspiration from the above installation instruction. If you have any doubts about the new car radio or the car radio installation process, then you can contact your dealer, communicate with someone experienced or turn to a professional for help.
Besides, it is essential for you to pick an ideal car radio for your beloved car. If you have no ideas, you can refer to a remarkable 2013 2014 2015 2016 KIA K3 car radio from Seicane. Here comes the link, please click:
This unit is modern enough to be compatible with a wide range of comprehensive features, so this unit can be regarded as one of the best replacements for your factory radio.
When you drive around unfamiliar places, even you have no good sense of directions, you can easily locate where you are currently and find the right way to get to your desired destinations under the guidance of the turn-by-turn directions and voice prompts. So you don’t have to worry about getting lost in unfamiliar places. Besides, you can freely listen to your favorite music behind the scene under GPS mode, and the music will automatically switch to GPS voice.
Additionally, you can simply connect your Bluetooth-enabled mobile phone to this car radio so as to enable you to dial, receive, reject and mute hands-free phone calls as well as freely enjoy your favorite music streaming from your phone music playlists without taking your hands off the steering wheel.
Wish you like this unit and good luck to you!