Audi Q3 2012 2013 GPS Navigation System Installation

1.Audi Q3 original stereo

 

 

 

2.1. Pry and take out the air-condition outlet panel

 

 

2.2. Take the air-condition outlet out

 

 

3.1. The screw is fixing the original screen

 

 

 

3.2. Take this screw out

 

 

4.1. Use a pry to loosen the screen panel

 

 

 

4.2. Take out the screen panel

 

 

 

5.1. Pry and loosen the screen’s rear cover

 

 

 

5.2. Take out the rear cover of the frame

 

 

 

6.1. Take these two screws out

 

 

6.2. Take the original screen out of the frame

 

 

 

7.1. New HD screen and original frame

 

 

 

7.2. Put the new HD screen onto the frame

 

 

8. Fix the new HD screen with screws

 

 

9.1. Use the dismantle tool to insert the hole of the original stereo

 

 

 

9.2. Take it out of dash board

 

 

 

10.1. Take the screw out which is fixing on glove box

 

 

 

10.2. Take out the glove box

 

 

11. Put the cables through the hole of the glove box

 

 

12. Pry and take out the side over of the dashboard (driver side)

 

 

 

13.1 Take out the screws as picture

 

 

 

14.1. Pry and loosen the panel of speed meter

 

 

 

14.2. Disconnect the plugs and take the panel out

 

 

 

15.1. Pull out the red plug from the gateway socket

 

 

 

15.2. Connect it with the extension cable

 

 

 

15.3. Connect the other side of extension cable’s plug to the socket

 

 

 

16. Connect the ISO connect from new system to the original plug

 

 

17. Connect the other side of the connector to the original stereo

 

 

 

18.1. Connect the new screen with the original plugs

 

 

18.2. Fix the cables on the panel

 

 

 

19. The original 2-pin plug for the screen does not need to be connected

 

 

 

20. Put the DVD GPS box into the glove box, and fix it there with bracket

 

 

 

21. Switch on and test the new unit

 

 

 

22. After installation

 

 

 

23. Tip A. Those two green CAN connectors should be connected together as the pictures

 

 

 

23. Tip B. Connect as the picture

 

 

23. Tip C. The cable marked “CAMERA+12V” is camera power supply, “CAMERA-IN” plug for camera video input