Most people want the installation steps of a dvd player when they come to the problem of dvd player installation.But most suppliers tell them that there is no installation instructions.Yes,no instructions.Because there are so many different cars, and every one is a little different. Dvd player output sources are vary. Some connect to external speakers via RCA cables and some have wireless headphones. So in the following the manual for the audio options is just for my particular player and hope to help you a lot.
Install Steps:
1.Route the wires from the DVD player out to the engine compartment. Your method for doing this depends on where the player is mounted. If it’s a headrest player, send the wires down through and underneath the seat. If it’s an overhead player, send the wires underneath the upholstery.
2.Attach the yellow wire to a constant 12-volt power source. The car battery itself is a good choice. Loosen the bolts on the battery, strip the insulation off the wire and secure the wire underneath the bolts.
3.Connect the red wire from the DVD player to the ignition switch. Insert the wire lead into one of the pin holes on the switch’s electrical connector.
4.Mount the black wire to a good ground. This can be any metal place on the car where you can secure the wire lead under a screw or something similar. Such screws can be found in the chassis.
car DVD player installed in your car must be connected to the car’s power source. There are usually three different color-coded wires attached to the player. The first one is connected to the ignition switch to supply power when the switch is on. The second one goes to a constant power source when the ignition is off. And the third wire grounds the DVD and power supply to prevent an electrical discharge.That is the all of install steps about car DVD.
After installation, your kids can watch movies on a long trip.You can go anywhere you want to.The gps navigation will help you a lot.You will never lost.So good!! Buy A DVD Player? Get Expert Advice Today!